Omron Pioneer LX User Manual page 97

Omron adept mobile robots platforms for research, education and development
Table of Contents

Advertisement

Table of Contents
Bumper Cover
This is the only cover that requires tools to install.
1.
Place the cover on the bumper.
It is held on with magnets, as well as screws.
2.
Install the screws, removed during the cover removal, at the sides of the cover.
Front Upper Cover
1.
Grip the cover at the two outer edges.
2.
Align the bottom edge of the cover so it slides under the chassis support.
3.
Tilt the top of the cover into position.
Rear Outer Cover
This cover houses the four rear sonar units, which must be reconnected once the metal brace across the
bottom is in the clip just below the battery access hole.
1.
Slide the metal brace into the clip in the chassis.
Watch the two magnets on the bottom of the cover, to align them with their mating magnets on the
chassis. This is your best guide for getting this cover in its proper place.
These are inboard of the clip holding the brace, so you will have to look on each side of the cover
to check their alignment.
2.
When the magnets at the bottom are lined up, tilt the cover up to within a few inches of the
chassis.
3.
Pull the sonar connectors out of the chassis, if they are not already out.
4.
Screw the four sonar connectors to their corresponding sonar leads.
Ensure that the labels for the connectors and leads match.
5.
Tuck the connectors into the four holes in the chassis, until just an inch of sonar lead is sticking
out.
6.
Tilt the top of the cover up to meet the chassis.
Side Covers
1.
Move the cover to within a few inches of the chassis, and plug in the light disc connector.
The light disc is connected to a connector, accessible on the inner side of the side cover.
2.
Place the top edge of the cover on the chassis, so the magnets hold it there.
Make sure the gaps on each side of the cover are the same width.
3.
Tilt the bottom edge of the cover down.
4.
Check each side of the cover to ensure that the cover edges on each side of the gap stick out the
same amount away from the chassis.
This is most likely to be uneven near the top of the cover.
Page 97 of 134

Advertisement

Table of Contents
loading

Table of Contents