Table of Contents
Advertisement
– Empty—the drive is empty.
– Encryp—the drive is writing encrypted data.
Center pane
•
Open Mailslot—(Administrator user only) Click or tap to unlock the mailslot on the selected module.
Mailslots must be enabled before the slots can be used as mailslots.
•
Open Magazine—(Administrator user only) Click or tap to unlock a magazine in the selected module.
Only one magazine in the library can be open at a time.
•
Configuration—(Administrator user only) Click or tap to configure the library.
•
Maintenance—(Administrator user only) Click or tap to access maintenance functions.
•
Operation—(Administrator user only) Click or tap to access operation functions.
•
Status—Click or tap to access status information.
•
Service Area—(Service user only) Click or tap to access functionality restricted to service engineers.
Both the service and administrator passwords are required to log in as the service user.
Configuring the library
When the library powers on the first time, it is configured with the default settings. The library must be
configured before use.
For the default settings, see Default and restore defaults settings on page 240.
Configuring the simplest configuration
This procedure results in a simple library configuration with RMI access, one partition, and no mailslots
enabled.
Procedure
1. If the initial administrator password has not already been set or the default library network settings
need to be modified, run the Initial Configuration Wizard from the Configuration area of the OCP.
You can skip the other configurations and complete them from the RMI.
2. Log in to the RMI as the administrator user.
3. On the Home screen, click Configuration.
4. In the right pane, click Partitions and then click Basic Wizard.
The wizard displays the configured partitions. When the library is first powered on and before partitions
are configured, this list will not have any partitions.
The wizard removes any existing partitions. If you see any partitions listed, verify that they can be
removed.
5. In the Information screen, click Proceed and then click Next.
54
Configuring the library
Advertisement
Table of Contents
