Table of Contents
Advertisement
Event code Message and description
8009
The timezone configuration has changed.
8010
A new partition was added.
8011
The network settings have changed.
8012
All expansion modules upgraded. The firmware for all expansion modules has been
upgraded.
8013
The NTP time synchronization configuration has changed.
8014
The SSH access was enabled/disabled.
8015
Level of media generation checking has changed.
LTO generation media checking has been enabled or disabled by the user.
8016
Library reset default settings invoked by user. The library settings have been reset to their
default values. See Default and restore defaults settings on page 240.
8017
Library firmware changed. The firmware process was initiated by a user.
8018
The Unlabeled Media Support configuration has changed.
8019
Robotics firmware version upgraded.
8020
A new key was created automatically. A new security token key was created through the
Encryption Kit automatic key generation mode.
8021
Secure Manager status changed.
8022
RMI/OCP Timeout configuration changed.
8023
MSL Encryption Kit / ESKM migration configuration changed.
8024
Mailslot / Magazine access control configuration changed.
8025
Mailslot / Magazine automatic relock duration changed.
8026
Robotics assembly change detected. The robotics assembly has been replaced.
8027
Power board has been exchanged. A drive power board has been exchanged or added.
8028
Power supply has changed. A power supply has been moved within the library or
replaced.
8029
The SNMP configuration changed.
8030
An SNMP target has been added.
Table Continued
Event codes
233
Advertisement
Table of Contents
