HP StoreEver MSL3040 User's And Service Manual page 221

Event Message and description
code
4044 One of the library tests failed because a
source element or destination element is not
accessible.
4046 The drive configuration failed because of
missing DPF license.
4047 The drive configuration failed because of
missing CPF license.
4048 The drive configuration failed because of
unsupported BDPF feature selected.
4049 The drive configuration failed because of
unsupported BCPF feature selected.
4050 Basic datapath failover occurred.
4051 A new encryption key could not be created
because media is loaded in one or more
drives. Unload the media from all drives and
then retry the manual key creation again.
4052 A new encryption key could not be created
because media is loaded in one or more
drives. Unload the media from all drives and
then automatic key generation will occur
during the next scheduled time frame, or
generate a new key server token key
manually.
4053 Manual control path failover from active to
passive drive failed; partition may be
disconnected from host.
Details and solution
The library either could not find the source
cartridge or the destination element was
unexpectedly full. This error can happen if a
cartridge in the destination element has an
unreadable barcode label.
1. See the event details to find the source
and destination elements.
2. Open the magazine and inspect the
source and destination drives or slots.
3. Unless the library is configured not to
use barcode labels, verify that all
cartridges have a high-quality proper
barcode label.
Disable path failover or install the necessary
failover license.
Disable basic path failover for this drive or
replace the drive with one supporting this
feature.
Check cabling and all network components
between the affected drive and host
computer.
Check cabling and all network components
between the affected drive and host
computer.
Table Continued
Event codes 221