Removing The Module Cables; Removing The Module From The Rack; Removing The Rack Shelves From The Rack - HP StoreEver MSL3040 User's And Service Manual

9. Install the module cables and magazines
10. Power on the library
11. Verifying the installation.

Removing the module cables

Remove all of the cables and cords from the module whose rack shelves are being replaced
Procedure
1. Remove any AC power cords.
2. Remove the expansion interconnect cables.
NOTE:
Completely removing the cables from both ends prevents damaging the expansion interconnect cables
during module removal and replacement.
3. Remove any SAS, FC, or Ethernet cables.
4. Remove any USB devices.

Removing the module from the rack

Obtain assistance to lift and stabilize the module during removal and replacement.
The module is supported by a pair of rack shelves. The rack shelves do not keep the module in the rack.
Be prepared to support the weight and control the movement of the module while sliding it out of the rack.
Procedure
Remove module from the rack.
For instructions, see Removing the module from the rack.
IMPORTANT:
To avoid personal injury or damage to the module, always support the bottom of the module where
the rack shelf contacts the module. Do not touch internal mechanical or electrical components while
moving the module.

Removing the rack shelves from the rack

Procedure
1. From the front of the rack, rotate the bottom of a rack shelf away from the rack posts to disengage it
from bottom of the front and rear adapter blocks.
2. Lift the rack shelf to disengage it from the top of the adapter blocks.
160 Removing the module cables