Table of Contents
Advertisement
Event
Message and description
code
4064
KMIP feature is not licensed.
4065
A tape alert event was reported by a drive.
4066
Automatic control path failover by disabling
LUN drive failed; partition may be
disconnected from host.
4067
Cleaning cartridge will soon be expired and
should be replaced.
4068
No cleaning cartridge found.
4069
Configuring the drive default map ID was not
possible.
Details and solution
Disable the KMIP feature or install the
necessary license.
Check event details for additional
information.
Check cabling and all network components
between the affected drive and host
computer.
Replace the cleaning cartridge.
When initiating a cleaning operation, the
library will use an unexpired cleaning
cartridge from the same partition as the tape
drive. If the partition does not contain an
unexpired cleaning cartridge, the library will
use an unexpired cleaning cartridge from an
unpartitioned area of the library. The library
will not use a cleaning cartridge from a
different partition. When enabling auto
cleaning, either ensure that each partition
has an unexpired cleaning cartridge or place
at least one unexpired cleaning cartridge in
an area that is not assigned to a partition.
The cleaning cartridge label must begin with
the letters "CLN" for the library to recognize
it as a cleaning cartridge. For more
information about auto cleaning, see
Configuring auto cleaning on page 109.
1. Verify that a properly labeled unexpired
cleaning cartridge is available in the
same partitions as the drives requesting
cleaning or in an unpartitioned area of
the library.
2. Perform a load and unload on any drives
that need cleaning to initiate
autocleaning.
Ensure that the drive is powered on, is
communicating with the library, and has
current firmware. If this error persists,
disable Secure Manager for the library and
re-enable it. Secure Manager is only
supported on LTO-4 and later generation FC
drives.
Table Continued
Event codes
223
Advertisement
Table of Contents
