Table of Contents
Advertisement
Removing the power supplies
Skip this step if the module does not have power supplies.
Procedure
1. Remove the AC power cords, if not done previously.
2. Loosen the two blue captive thumbscrews on the power supply with your fingers or a #2 Phillips
screwdriver.
3. Using the thumbscrews (one on each side), slowly pull the power supply approximately 10 cm (4
inches) from the back of the module.
4. Use one hand to completely remove the power supply from the module while using the other hand to
support the bottom.
5. If the module had two power supplies, remove the other power supply.
Removing the module from the rack
Obtain assistance to lift and stabilize the module during removal and replacement.
The module is supported by a pair of rack shelves. The rack shelves do not keep the module in the rack.
Be prepared to support the weight and control the movement of the module while sliding it out of the rack.
Procedure
1. If you are removing a base module from a library that does not have expansion modules, use a #2
Phillips screwdriver to loosen the captive fasteners until the module is released from the rack.
142
Removing the power supplies
2
1
Advertisement
Table of Contents
