Moving Library Cover Plates - HP StoreEver MSL3040 User's And Service Manual

2. If you are removing a module that has a module immediately above and/or below it:
a. From the front of the library, use a #2 Phillips screwdriver to loosen the captive fasteners until the
module being removed is released from the rack.
b. Loosen the captive fasteners two full turns on adjacent modules.
c. From the back of the library, unlock the alignment mechanisms connecting the module with the
adjacent modules.
3. With assistance and while supporting the bottom of the module in the areas supported by the rack
shelves, slide the module out of the rack and set it on a sturdy static-safe work surface.
Only support the module in the areas that are supported by the rack shelves.
IMPORTANT:
To avoid personal injury or damage to the module, always support the bottom of the module
where the rack shelf contacts the module. Do not touch internal mechanical or electrical
components while moving the module.

Moving library cover plates

The library has removable top and bottom cover plates.
• The replacement base module is shipped with top and bottom cover plates.
• The replacement expansion module is shipped without cover plates.
Procedure
1. Unpack the replacement module and place it on a sturdy work surface. Save the packaging materials
to return the damaged module.
2. Move the cover plates as necessary so the replacement module has the cover plates in the same
location as the damaged module.
1
2
Moving library cover plates 143