Installing Or Replacing A Tape Drive; Removing A Drive Bay Cover - HP StoreEver MSL3040 User's And Service Manual

2. Pull the magazine straight out of the library while supporting it from the bottom.

Installing or replacing a tape drive

WARNING:
Only individuals who are informed about the procedures and risks should replace or upgrade this
tape drive assembly. Read all troubleshooting documentation and procedures before proceeding
with repair or upgrade procedures. Hazardous moving parts exist inside this product. Do not insert
tools nor any portion of your body into the drive bay openings.
Procedure
1. Remove the drive bay cover or Remove the tape drive.
2. Install the tape drive.
3. Connect the FC cable or Connect the SAS cable.
4. Configure the FC drive.
5. Verify the tape drive installation.

Removing a drive bay cover

Procedure
1. Identify the location for the tape drive.
Install the first tape drive in the bottom drive bay. Install an additional drive in the next higher open
drive location.
Only install a full-height tape drive in the bottom two half-height drive bays.
2
1
Installing or replacing a tape drive 123