Table of Contents
Advertisement
c. Lower the cover front end by about 10 cm and pull gently forward to disengage from the cover pivot
point at module center.
d. Remove the cover from the module.
2. Install the bottom cover plate on the other module.
a. Place the module upside-down on a work table.
b. Insert the back of the cover at the module center.
c. Lower the cover front edge until you feel a hard stop and the cover locks in at the front of the
module.
Installing the expansion modules in a rack
Skip this step if the library does not have expansion modules.
TIP:
When installing multiple expansion modules, work from the base module to the top of the library and
then from the base module to the bottom of the library.
Prerequisites
•
The rack shelves are installed.
•
The library cover plates are on the modules that will be on the top and bottom of the library.
Procedure
1. From the front of the rack while supporting the bottom of the module in the areas supported by the
rack shelves, set the back of the expansion module on the front of the rack shelves. Push the module
into the rack until the front of the module contacts the rack posts.
2. Verify that this module has been installed directly above or below its adjacent module and is contained
with the correct 3U volume.
2
1
Installing the expansion modules in a rack
37
Advertisement
Table of Contents
