Table of Contents
Advertisement
Procedure
1. If an expansion module will be installed above the base module, move the top cover plate from the
base module to the top of the expansion module that will be installed at the top of the library.
2. If an expansion module will be installed below the base module, move the bottom cover plate from the
base module to the bottom of the expansion module that will be installed at the bottom of the library.
Moving the top cover plate
Procedure
1. Remove the top cover plate from the current module.
a. Unlock the top cover using two small screwdrivers.
b. Lift the cover front end by about 12 cm.
c. Gently pull the cover forward to disengage from the pivot point at the module center.
2. Install the cover plate on the other module.
a. With the front of the top cover raised approximately 12 cm, engage the rear of the cover at the
module pivot point located at the back of the opening.
3
1
2
Moving the top cover plate
35
Advertisement
Table of Contents
