Table of Contents
Advertisement
3. Look into the lowest module and verify that the entire area of the bottom cover is free of any objects
that might obstruct the robotic assembly path. Clear any obstructions.
4. Replace the magazine and then power on the library.
The library will perform an initialization and inventory.
5. Verify that no further critical events were generated.
If the library still reports an obstruction, continue checking for tape cartridges that are out of place or
have loose labels.
•
Remove and inspect each magazine.
◦
Check for cartridges that are not seated properly in the storage or mail slots.
◦
Check for loose cartridges.
◦
Check for loose bar code labels.
◦
Check for any other objects out of place on the magazine or in the magazine bay.
•
Inspect each tape drive for tape cartridges or barcode labels that might block the path of the
robotic.
•
Inspect the robotic for loose cartridges or other debris.
Troubleshooting tools, procedures, and information
183
Advertisement
Table of Contents
