Download  Print this page
   

Advertisement

HP
StorageWorks
Inspect the contents of the kit:
Documentation CD – User guide and Web links
for product registration, drivers, and technical
support.
Warranty Card – Information about accessing
product warranty details.
Safety Booklet – Important product safety
information.
SCSI Terminator(s) – Used in cabling the library.
SCSI Cable(s) – Used in cabling the library.
MSLUtil Diagnostic Software – Product
diagnostic utility.
Serial Cable – Used in conjunction with MSLUtil
diagnostic software.
Note:
Accessory kit contents may vary
by product. Optional accessories include
rack mounting hardware for mounting the
library into an HP Rack 10,000 Series
enclosure and a rack system/e or
AlphaServer H9A rack enclosure.
Refer to the documentation for those kits.
MSL6000
Series
Tape Library
Setting Up
Your Library
FRONT VIEW:
1. Left magazine door
2. Left magazine
3. Mail slot
4. Viewing window
REAR VIEW:
1. Power supply
2. Power switch
3. Pass-through
mechanism interface
controller
4. Pass-through
mechanism mounting
location
5. GUI touch screen
6. Library status LED
7. Right magazine
8. Right magazine door
5. Blank cover
6. Tape drive 0
7. Accessory PCI slots (2)
8. Library controller
board

Advertisement

   Related Manuals for HP Tape Library MSL6000 Series

   Summary of Contents for HP Tape Library MSL6000 Series

  • Page 1 Optional accessories include mechanism interface 6. Tape drive 0 rack mounting hardware for mounting the controller 7. Accessory PCI slots (2) library into an HP Rack 10,000 Series enclosure and a rack system/e or 4. Pass-through 8. Library controller mechanism mounting board AlphaServer H9A rack enclosure.
  • Page 2: Getting Connected

    Drive 1 Drive 0 Depending on the model, your library may look different from the ones illustrated in this procedure. Refer to the HP StorageWorks MSL6000 Series Tape Library User Guide for additional procedures. Drive 1 Drive 0 Drive 3...
  • Page 3: Install The Library

    Back of rack Note: Rail front brackets are threaded to directly accept screws. Rear brackets are not threaded and require installation of cage nuts in the rack enclosure’s rear vertical rails. See the documentation Front of rack provided with your rack enclosure for detailed installation instructions.
  • Page 4: Power On The Library

    A maximum of one tape drive per bus is recommended for Ultrium 460 and 960 tape drives. • HP recommends that the robot and drive 0 be attached to host bus 0. • For Windows servers, power on the library before powering on the server.
  • Page 5 Navigating the GUI Menu MENU VIEW SYSTEM DATA EDIT OPTIONS Library Options Library SCSI Options SCSI Network Options Network Library Info Passwords Cartridge Map UTILITIES Diagnostics Maintenance Cartridge Cycle Clean Drive (service only) Replace Drive Factory Drive Cycle (service only) Drive Format BarCode Cycle Set User Defaults...
  • Page 6 © 2005, 2007 Hewlett-Packard Development Company, L.P. Third Edition (January 2007) Part Number: 331707-003 *331707-003* 331707-003...

Comments to this Manuals

Symbols: 0
Latest comments: