Table of Contents
Advertisement
◦
N-Port ID—Logical port identifier for the FC drive port.
◦
Fibre Channel Fabric Log-in Name (LTO-6 only)
•
Secure Mode—Indicates whether the drive is running in Secure Mode.
Viewing network status
Procedure
In the Status > Network screen you can see the status of the library networking.
Network Status screen parameters
•
Host Name—Library hostname
•
Domain Name
•
Protocol—IPV4 or IPv6
•
MAC Address— A unique identifier for the library controller network interface
•
Link Status—Enabled or disabled
•
Link Speed—Speed of the Ethernet connection to the library
•
Duplex—Enabled or disabled
IPv4 settings
•
DHCP—When Enabled, the library requests an IP address from a DHCP server each time the library
is powered on.
•
Address—IP address in use by the library. If DHCP is enabled, this address was obtained from the
DHCP server. When DHCP is not enabled, the address was configured.
•
Netmask—The network mask of the library controller used when DHCP is not enabled.
•
Gateway—The gateway used when DHCP is not enabled.
•
DNS 1
•
DNS 2
IPv6 settings
•
Stateless Addressing—When Enabled, the library will generate an address for itself based on the
routing information obtained from a router advertisement and the MAC address. The library can
manage up to five global addresses at the same time, which can be assigned from different routers.
•
Static Addressing—When Enabled, the library will use a statically configured address.
•
Static Assigned Address—The IPv6 address when Static Addressing Enabled is On.
Command View TL status parameters
Library information
Viewing network status
117
Advertisement
Table of Contents
