Table of Contents
Advertisement
The gap between modules must be less than 4mm.
3. Use a #2 Phillips screwdriver to tighten the captive fasteners on each side of the expansion module
until they are finger tight. Do not over tighten.
4. Repeat for any other expansion modules.
5. Verify that the top cover plate is at the top of the library and that the bottom cover plate is at the bottom
of the library.
Aligning and connecting modules
Skip this step if the library does not have expansion modules.
Procedure
1. From the front of the library, loosen the screws on each of the modules two full turns.
2. From the back of the library, starting with the bottom pair of modules, align each module with the
module below. Repeat for each pair of adjacent modules.
a. Lock the alignment mechanism.
If the alignment mechanism has a lock, slide the lock to the left, move the alignment mechanism to
the locked position, and then release the spring-loaded lock.
If you encounter resistance, adjust the position of the upper module so the pin in the alignment
mechanism moves into the mating hole in the lower module.
3. Verify that the lowest module in the library has its alignment mechanism in the unlocked position.
4. From the front of the library, use a #2 Phillips screwdriver to tighten the captive fasteners on each side
of all of the modules until the fasteners are finger tight. Do not over tighten.
5. From the back of the library, connect each adjacent pair of modules with expansion interconnect
cables, if not already connected.
38
Aligning and connecting modules
1
2
Advertisement
Table of Contents
