Table of Contents
Advertisement
•
Setting the administrator password is required for any user with administrator or security roles to log in
from the RMI.
•
Collect the LDAP server configuration settings.
•
LDAP server configuration is dependent on the company IT environment and security model. See your
IT administrator for the settings for your environment. Before using the wizard, you will need to know:
1. IP address and port for the primary and backup LDAP servers
2. Common Name for the library administrator
3. Base Distinguished Name and Domain.
4. Distinguished Name for the library administrator. These are parameters needed to search for
potential library users in the LDAP server. For example,
OU=lnternal,OU=Users,OU=RW,DC=libgroup,DC=local.
5. Attribute Mapping, Username. For most Windows Active Directory environments, the Username
field under Attribute Mapping should bet set to sAMAccountName.
6. If SSL is required for the LDAP server. This field is likely required for newer versions of LDAP
servers.
Configuring Command View for Tape Libraries integration
For more information about Command View TL, see the HPE StoreEver Interface Manager and
Command View for Tape Libraries User Guide, available from the Hewlett Packard Enterprise website at
http://www.hpe.com/support/cvtl.
Procedure
1. Verify that SNMP is enabled.
2. Navigate to the Configuration > Command View TL Configuration screen.
3. Configure the library information.
•
Name—The name of the library that will be displayed in the Command View TL interface. The
default is HPEMSL3040 <serial number>.
•
Serial Number—The serial number of the base module. This cannot be modified.
•
Management URL—The URL of the management station, including port. For example: http://
192.0.2.24:8099.
4. Configure the product information.
•
Name—MSL3040. This cannot be modified.
•
Version—Library firmware version.
5. Configure the contact information.
88
Configuring Command View for Tape Libraries integration
Advertisement
Table of Contents
