Table of Contents
Advertisement
NOTE:
Use extreme caution to prevent damaging other parts of the module.
A new spooling cable is provided with the replacement robotic assembly.
4.
Remove the expansion module containing the robotic assembly while carefully guiding the free
spooling cable; see Preparing to remove the robotic assembly and spooling mechanism on
page 153. While there may be minor differences, these instructions for a base module will also apply
to an expansion module.
5.
Remove the robotic assembly from the expansion module. See the initial steps in Removing the
robotic assembly and spooling mechanism from the base module on page 154.
6.
Replace the expansion module in the rack; see Installing the base module in the rack on page 34.
While there may be minor differences, these instructions for a base module will also apply to an
expansion module.
7.
Remove the base module from the rack.
8.
Remove the spooling mechanism from the base module using the next set of steps in Removing the
robotic assembly and spooling mechanism from the base module on page 154.
9.
Install the new robotic assembly and spooling mechanism; see Installing the robotic assembly and
spooling mechanism into the base module on page 156.
10. Replace the base module in the rack; see Completing the robotic assembly and spooling
mechanism installation on page 158.
The cabling and alignment instructions also apply to the expansion module that was removed.
Clearing obstructions from the library
For proper operation, the robotic assembly must be able to reach the bottom of the library.
Procedure
1. Power off the library by pressing the front power button for 5 seconds and then select the Default Park
Location.
The library will park the robotic assembly in the base module behind the OCP.
2. Remove the left magazine from the lowest library module.
For instructions on using the manual magazine release, see Unlocking a magazine with the manual
release.
182
Clearing obstructions from the library
Advertisement
Table of Contents
