5. Verify that the box flaps close without bulging and then tape the box closed.
6. Strap the shipping box securely to the pallet.
Replacing the center bezel
Prerequisites
Tools required:
•
#2 Phillips screwdriver
•
A small flat head or Torx screwdriver
•
Small flashlight
Procedure
1. Power off the library. Verify that the robotic assembly is parked in the base module.
2. Remove the magazines
3. Gain access to remove the front bezel
4. Remove the front bezel
5. Install the front bezel
6. Reinstall the module
7. Power on the library
8. Verify the replacement
Gaining access to remove the front bezel
If the damaged module is installed in a rack, extend the module approximately 5 cm (2 inches) out of the
rack to access the bezel release latches on the bottom of the module.
Replacing the center bezel
147