Table of Contents
Advertisement
If you encounter resistance, adjust the upper module position. The pin in the alignment
mechanism must move easily into the hole in the lower module. When the alignment
mechanism is in the locked position, release the spring-loaded lock if present.
CAUTION:
Do not use the alignment mechanism to force the modules into alignment.
The alignment mechanism is designed to hold the modules in position once they
are aligned. It is not intended to adjust the module positions.
III.
Verify that the lowest module in the library has its alignment mechanism secured in the
unlocked position.
IV.
Move to the front of the library. Tighten the captive fasteners on all modules until the
fasteners are finger tight. Do not over tighten.
9.
If the library has expansion modules under the base module and the robotic shipping bracket is
available, install the robotic shipping bracket in the middle drive bay of the base module.
a. Remove the drive bay cover or tape drive from the drive bay, if necessary.
b. Look into the open drive bay and verify that the robotic assembly is visible.
c. Slide the shipping bracket into the middle drive bay until it is fully seated. Secure the bracket with
two M3x0.5 6mm screws, which are stored just under the handle on the bracket.
1
2
Library shipping procedures
187
Advertisement
Table of Contents
