Table of Contents
Advertisement
Installing optional power supplies
Each module supports up to two power supplies. The base module is shipped with one power supply
installed. Expansion modules are shipped without a power supply.
If an expansion module will have one or more tape drives, it must have a power supply.
When present and connected to a different AC power source, the second power supply in the module
provides redundancy.
Procedure
1. Using a #2 Phillips screwdriver, remove the power supply bay cover.
When installing the first power supply in an expansion module, the power supply can be installed in
either bay.
2. Position the new power supply on the alignment rails.
3. Slide the power supply into the module until it is flush with the back panel of the module.
Installing optional power supplies
39
Advertisement
Table of Contents
