Configuring The Library; Reconfiguring The Backup Software - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade Kit

NOTE
Upgrading a 20-Slot Library to 40 or 60 Slots
Verifying the Connection
To run these tests:
1. From
Administration,
options. Select the
2. From , use the
Run Test
3. Select to select the test.
[OK]
4. Select the number of times this test will run (if needed).
Select to abort a test. The current test cycle completes before the
[Stop]
test stops.
5. Select to start the test cycle.
[
Run]
The test results will display at the conclusion of the test cycle.

Configuring the Library

Check the mailslot configuration. Since the mailslot will now be the top
right-hand drawer of the upgraded library, remove the tapes from the old
mailslot (0, 1, or 5 slots), and add them to the new mailslot on the top
module. When you power the library on, the library will automatically
reconfigure itself for the upgraded capacity and new mailslot.
The firmware automatically recognizes the upgrade status, so no
additional library configuration is needed.

Reconfiguring the Backup Software

Your software applications may need to be reconfigured or, in some cases,
reinstalled after you have installed additional drives or slots into the
library. In addition, some backup software applications may require the
purchase of additional add-on components and/or licenses when
increasing the number of storage slots or drives. Contact your software
application provider for more information or if newly installed storage
slots and drives are not recognized by your backup software application.
2-22
select to display additional administrative
[More]
menu.
Run Test
or key to view available tests.
[-] [+]
Chapter 2