Table of Contents
Advertisement
•
Are all available hosts already assigned to other access groups?
Each host can only be assigned to one group. If necessary, click Back twice and then remove the
host from another access group.
•
Is the host configured in the same zone controlled by the FC switch?
Secure Manager creates access groups as a refinement of zones configured by the FC switch. If
you are using FC switch zoning, the host and library must already be in the same zone.
•
Is the host not physically connected to into the SAN?
If not, connect the host to the SAN or create a host in the wizard to be connected into the SAN
later.
6. Click Finish.
Changing the name of an access group when using Secure Manager
Procedure
1. Navigate to the Configuration > Secure Manager screen.
2. Click Edit next to Access Group Configuration and Host(s) selection and then click Next.
3. Select the group from the list of Existing Groups, click Change Access Group Name, and then click
Next.
4. Enter the new group name and then click Finish.
Deleting an access group when using Secure Manager
Procedure
1. Navigate to the Configuration > Secure Manager screen.
2. Click Edit next to Access Group Configuration and Host(s) selection and then click Next.
3. Select the group from the list of Existing Groups, click Delete Host Access Group, and then click
Finish.
Adding a host to an access group when using Secure Manager
Procedure
1. Navigate to the Configuration > Secure Manager screen.
2. Click Edit next to Access Group Configuration and Host(s) selection and then click Next.
3. Select the group from the list of Existing Groups, click Add Host to Group, and then click Next.
4. Select one or more available hosts to add to the group and then click Finish.
If no hosts are listed, check the following:
Changing the name of an access group when using Secure Manager
95
Advertisement
Table of Contents
