Table of Contents
Advertisement
MSD-72 Series User's Guide
9.12.7 Command execution key: Lighting condition
Top → PRESET COMMAND → COMMAND TALLY
Menu
Setting for
Each control command execution key
Setting value
REGISTERED [Default]
EXECUTION: Lights while a control command is executed
If you set "LINK" to "ON", you can change all lighting conditions at once.
*1
There are two planes (PLANE A and B) for each execution condition of COMMANDs A to I. If you register
control commands for both planes, the control commands are executed alternatively every time you press the
command key as follows.
[Table 9.27] Lighting conditions of control command execution keys
Lighting
If you register a command only for one
condition
REGISTERED Lights if a control command is registered
Lights while a control command is
EXECUTION
executed
*2
If execution time is 500 ms. or shorter, it lights for only 500 ms. It can be set to blinking in "9.12.8 Blinking
time of " that follows.
9.12.8 Blinking time of command execution key
Top → PRESET COMMAND → FLASH TIME
Menu
Setting for
Each control command execution key, each display power key
Setting value
EXECUTION: Blinks while a control command is being executed [Default]
OFF: Not blink
1sec. to 1000sec.: Blinks for the specified time (1 to 1000 sec.)
You can set the blink time of command execution keys and power switch of sink devices during command
execution.
110
*1
: Lights if a control command is registered
plane
*1 *2
If you register commands for both two
Lights if PLANE A will be executed at the
next press; blinks if PLANE B will be
executed at the next press.
Lights if PLANE A will be executed at the
next press; turned off if PLANE B will be
executed at the next press.
planes
Advertisement
Table of Contents
