Step 7: Install Stratagy Admin Software (Vsa.3X); Step 8: Connect Stratagy Admin Pc To Stratagy - Toshiba Stratagy IVP8 Installation And Maintenance Manual

Step 7: Install Stratagy Admin Software (VSA.3x)

Note Loading the Stratagy Admin software can be done before/after connecting the Stratagy
Admin PC to the Stratagy.
The Stratagy Admin PC, connected to the Stratagy (see
Stratagy" below), must meet the following specifications:
•
IBM-compatible
•
3.5" 1.44 (high-density) floppy-disk drive
•
Hard drive with a minimum of 5MB of available disk space
•
580KB RAM free memory
Do not install the Stratagy Admin VSA.3x software into an existing Admin2 or
CAUTION!
Admin3 directory used for Release 2 systems. If you do, file corruption can
occur when communicating with a Stratagy.
➤
To install Stratagy Admin Software
1. Insert the Stratagy Admin disk into the floppy disk drive of the Stratagy Admin PC.
2. Access the DOS prompt (C:\).
3. To begin the installation procedure, type
a:install c:\VSA3x
where: x = the version letter of the Admin software you are installing.
Note It is recommended that you not overwrite the current Stratagy Admin directory but create a
new directory.
4. Press any key to continue. The Stratagy Admin program is installed on drive C: in subdirectory
VSA3x.

Step 8: Connect Stratagy Admin PC to Stratagy

Communication between the Stratagy Admin PC and the Stratagy is accomplished by one of two
methods: local or remote.
Stratagy uses the serial Port 2 by default to communicate with the Stratagy Admin PC (see
1-2). This setting can be changed using the admin_port parameter in the Stratagy System
Configuration file (see
Stratagy I&M 06/02
"System Parameters" on page 4-14
Step 7: Install Stratagy Admin Software (VSA.3x)
Step 8 "Connect Stratagy Admin PC to
for detailed information).
Installation
Figure
2-11