Step 3: Shut Down Strata Ctx/Strata Dk; Step 4: Install Stratagy; Flash - Toshiba Stratagy IVP8 Installation And Maintenance Manual

•
Enable the Strata DK to receive DTMF signalling from the IVP8:
•
For DK40i/DK40/DK16e/DK16: Set code 92 for slot 00 for the K5RCU, K5RCU2, or
K4RCU3.
•
For DK424i/DK424/DK280: Set codes 92, 93, or 94 for slot 00 for the RRCS installed
on the RCTU.
•
For DK24, DK56, DK96: Set codes 92 and 93 for CRCU.
•
Set code 64 for the slot where the PDKU resides. IVP8 monitors this slot for the DSS/Busy
Lamp feature (see
Note For DK40/DK16e/DK16: slot 11 in the Base Cabinet must be set for code 64.
•
If SMDI is desired with the Strata DK424i/DK424/DK280: Set PIOU/PIOUS/RSSU for
code 43 or RSIU/RSIS for code 49 to enable the SMDI port (see Program 76 if installing
RSIU or RSIS SMDI port).
2. Program the Strata DK system for voice mail integration. See the Strata DK Programming
Manual for details.

Step 3: Shut Down Strata CTX/Strata DK

➤
Turn off the main power switch to the Strata CTX/Strata DK system.

Step 4: Install Stratagy

Flash

➤
Since the Flash and the telephone system must be physically connected, place the Stratagy by
the telephone system.
Power Requirements
We recommend the following for the Flash unit:
•
A 15A circuit breaker and dedicated AC circuit that does not have an On/Off wall switch
(avoids accidental power interruption).
•
A UPS in areas where the power source is not stable (frequent power failures, brownouts, etc.).
Environmental Considerations
The area in which you locate the Flash affects its operation. Place it in an appropriate area that is:
•
Dry, clean, well ventilated, lighted (avoid placing it in direct sunlight), and easily accessible
•
Not subject to extreme hot or cold, corrosive fumes, dust, other airborne contaminants, or
excessive vibration
Stratagy I&M 06/02
"Busy Station Identification"
Step 3: Shut Down Strata CTX/Strata DK
on page 1-10).
Installation
2-7