Introduction; Limited Warranty; Revision History; Software Revision - Daikin MicroTech II Installation And Maintenance Manual

Limited Warranty

Consult your local Daikin Applied Representative for warranty
details. To find your local Daikin Applied Representative, go to
www.DaikinApplied.com.

Revision History

Version Release Date
ED 15062-0 January 2, 2003
ED 15062-1 June 30, 2004
ED 15062-1 May 18, 2005
ED 15062-2 November 20, 2005
ED 15062-3 June 30, 2006
ED 15062-4 February 2, 2009
ED 15062-5 April 20, 2009
ED 15062-6 Jan 21, 2013
ED 15062-7 June 25, 2015
www.DaikinApplied.com
Description
Initial release.
1. Added WGZ and WGS to Table 3.
2. Changed BACnet Communication
Module Firmware Rev number from
3.09 to 1.03.
3. Added BCM.CIT to Software
Revision Table.
4. Added WGS to front page and
Chiller Model table.
5. Changed the "Full Reference" label
in the "Variable Details" tables to
"Object Name."
6. Removed Device Object
Name and Property from the "Full
Reference"(Object Name.)
7. Added units to "Who is Frequency"
description.
1. Added HSC and TSC to front page
and Chiller Model table.
1. Corrected BACnet Alarm Table
2. Added WCC to front page, Chiller
Models and Alarm Table
3. Updated "Set up the Unit for
Network Control" section
Removed all references to BACnet IP/
Ethernet. Refer to ED 15100 (new)
Removed information regarding
the previous BACnet MS/TP
communication module (PN
350147406) which has been replaced
with a new hardware/firmware platform
(PN 350147407). Added references to
TGZ chiller. Added 76800 baud rate.
Added information in the Configuring
the Unit Controller section regarding
the BACnet Configuration Tool,
which is required for setting certain
parameters with the new BACnet
communication module.
Removed Table 1 (Receive Heartbeat
Variables) and replaced Data Integrity
section with new text description
of ncidefaults and nciRcvHrtbt
interaction.
Added individual compressor data
points.
Specified that hours are reported at
1/10th the actual hours. Corrected
Compressor Status for BACnet to be
an enumerated value, not a bit field.
Removed references to out-dated
software/firmware. Added clarification
to "Actual Capacity" data point for
centrifugal chillers. Changed branding.
Changed description of Chiller On Off
data point.

Software Revision

This edition documents the following versions of the
standard MicroTech II BACnet
®
and LONWORKS Communication Module software and all
®
subsequent revisions until otherwise indicated. However, if
your software is of a later revision, some of the information in
this document may not completely describe your software.
Software
LONWORKS ® Communication Module Firmware
BACnet Communication Module Application Software Version
®
5 ED 15062-7 • MICROTECH II CHILLER CONTROLLER
I
nTroduCTIon
Communication Module
®
Revision
CHCHLA24
2.00
I
nTroduCTIon