Extra-Ordinary Maintenance Operations; Checking The Operation Of The Cardiotester Receiver; Checking The Operation Of The Hand Sensor Receiver; Checking The Working Conditions - Technogym RUN PERSONAL Service Maintenance Manual

RUN PERSONAL: Service & maintenance manual - rev. 3.1

11.2. EXTRA-ORDINARY MAINTENANCE OPERATIONS

11.2.1. C
HECKING THE OPERATION OF THE CARDIOTESTER RECEIVER
1. Using a separate heart rate monitor, put on the transmitter band and check that the machine and
the separate monitor both measure the same heart rate, and that when the band is disconnected
the machine does not receive any signal.
2. Using a heart rate frequency simulator, check that the machine detects variations in the heart
rate.
11.2.2. C
HECKING THE OPERATION OF THE HAND SENSOR RECEIVER
1. Using a separate heart rate monitor, grasp the hand sensors and check that the machine and the
separate monitor both measure the same heart rate, and that when the sensors are released the
machine does not receive any signal.
11.2.3. C
HECKING THE WORKING CONDITIONS
1. Check that the machine is connected directly to the wall outlet, without any extension cords, and
that the outlet is correctly earthed.
2. Using a multimeter, check that the machine earth node is correctly connected to earth.
11.2.4. C
HECKING THE WIRING AND CONNECTIONS
1. Open all the machine guards.
2. Check the condition of all the cables:
• External conditions;
• Possible rusting of the connectors;
• Electrical continuity of the individual wires;
• Isolation of the individual wires toward ground.
3. Repair and/or replace any non-conforming wires.
4. Check the condition of the fuses using a tester.
11.2.5. C
HECKING THE STATE OF WEAR OF TREAD BELT AND RUNNING DECK
1. Disassemble the rear and driving rollers, the running deck and the tread belt.
2. Check the state of wear of both the running deck and the tread belt. Replace if there are evident
signs of wear.
3. Using a clean cloth, wipe the entire surface of the running deck and the underside of the tread
belt.
11.2.6. C
HECKING THE WEAR OF THE MOTOR ROLLER
1. With the rear and driving rollers, running deck and tread belt disassembled, check the state of
wear of the driving roller. Replace if there are evident signs of wear.
2. With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
Page 11.3