Routine Maintenance Operations; Internal Cleaning Operations; Checking The State Of Wear; Checking The Tension And Centering Of The Tread-Belt - Technogym Forma Service Maintenance Manual

FORMA: Service & Maintenance manual - rev. 3.0

10.2. ROUTINE MAINTENANCE OPERATIONS

These operations can be performed by the machine owner and do not require any
special skills.
The routine maintenance operations involve simple cleaning and lubrication actions and checks on
the state of wear and safety devices, in order to ensure correct and safe operation of the machine. It
is recommended to carry out these operations at least once a month.
For the routine maintenance of the machine, proceed as follows:
10.2.1. I
NTERNAL CLEANING OPERATIONS
1. Turn off the machine, by placing the switch in the 0 (OFF) position.
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Clean the interior using a vacuum cleaner, taking particular care with the tread-belt motor, the
inverter and the electronic circuit boards.
WARNING: when carrying out these operations, be careful not to damage the cables.
5. Move the machine and clean the floor under the machine using a vacuum cleaner.
10.2.2. C
HECKING THE STATE OF WEAR
1. With the machine stopped, check the state of wear of the entire surface of the tread-belt, turning
it by hand. If any problems are observed, call in the authorized Technogym Technical Service.
10.2.3. C
HECKING THE TENSION AND CENTERING OF THE TREAD
1. With the machine stopped, check the tension on the entire surface of the tread-belt, turning it by
hand. If any problems are observed, call in the authorized Technogym Technical Service or
adjust the tension.
2. With the machine running at approximately 10 Km/h, check the centering of the tread-belt. If
any problems are observed, call in the authorized Technogym Technical Service or adjust the
centering.
10.2.4. C
HECKING THE
1. With the machine turned on and running at approximately 5 Km/h, operate the safety switch and
check that the machine stops and shows the "SAFETY SWITCH" message on the display.
"S "
AFETY SWITCH
-
BELT
Page 10.3