GE F650 Instruction Manual page 745

E.1 PROCOME PROTOCOL APPENDIX E
When value NONE is selected in the COMM Port setting the protocol is not enabled. The COM1 selection enables
PROCOME for the COM1 (remote) serial port.
Slave Number:is the PROCOME slave number.
Baudrate and parity for COM1 must be set in the "Setpoint>Communications>Serial Ports menu".
Procome Configuration:
The procome data configuration is preformed through the "Setpoint>Procome Configuration" tool when communication via
Ethernet with the device. The procome configuration file can be retrieved and sent to the relay easily. The relay must be
switched off and on to start working with the new procome configuration set by the user. The relay by default has no
procome configuration. For more information about procome configuration see chapter SETTINGS -> "procome
configuration".
E
E-2 F650 Digital Bay Controller GEK-106310AB