GE F650 Instruction Manual page 292

Digital bay controller

Hide thumbs Also See for F650:

Table of Contents

This menu is used for selecting the digital channels to be included in oscillography records, and the oscillo trigger signal. As

for the above-described settings, the trigger selection can be any of the signals provided by the relay or a logic combination

settings are described below:

Select checkbox enables or disables a digital channel and the oscillography trigger.

Name setting defines the name of the digital channel to be included in oscillography records.

Source setting defines the source or signal to be recorded in that specific channel, which can be selected among all

the operands available in the signals menu.

NOT checkbox inverts the enabled digital channel signal.

OR checkbox to select a group of operands instead of a single one. The relay performs an OR of the signals, and its

output produces operation.

This screen is used for the configuration of digital channels and oscillography trigger. The rest of parameters,

such as function enabling/disabling, sampling rate, number of oscillography files, etc. must be set on the

Setpoint > Product Setup > Oscillography menu.

GEK-106310AB

Figure 5–50: OSCILLOGRAPHY CONFIGURATION

F650 Digital Bay Controller

5.9 RELAY CONFIGURATION

5.9.5 OSCILLOGRAPHY