GE F650 Instruction Manual page 374

Digital bay controller

Hide thumbs Also See for F650:

Table of Contents

7 IEC 61850 PROTOCOL

7.1.3.2 USERST BIT PAIRS

Remote Outputs 1 to 64 originate as GSSE messages to be transmitted to remote devices. Each digital point in the

message must be programmed to carry the state of a specific PLC operand. The setting above is used to select the

operand which represents a specific UserSt function to be transmitted. They are displayed in EnerVista 650 Setup:

Actual Values > Input/Outputs > Remote Outputs > User St

Each User Set point can be ONLY programmed and displayed in EnerVista 650 Setup (see Figure 3):

Setpoint > Relay Configuration > Remote Outputs

Actual > Inputs/Outputs > Remote Outputs > User St

GEK-106310AB

7.1 IEC61850 GENERIC SUBSTATION STATE EVENT (GSSE)

Figure 7–3: REMOTE OUTPUTS > USER SET

F650 Digital Bay Controller