GE F650 Instruction Manual page 314

5 SETTINGS 5.12 PROCOME CONFIGURATION
5.12PROCOME CONFIGURATION
The PROCOME Configuration option will only be available if the F650 supports this protocol (5 in the ordering code for
protocol selection).
This menu is located in Setpoint > PROCOME Configuration
When opening the Procome configuration tool, the program will ask to open an existing "f650procome.cfg" file, if this option
is cancelled, the user will enter in the procome configuration tool with no file selected. There is the possibility to retrieve the
procome configuration from the relay and start working with it. The user can "save" the changes to the f650procome.cfg
configuration file, and send it to the relay "Send Configuration". In order to start working with the new procome
configuration, the relay must be switched off and on.
The procome slave can be identified (besides the slave number) with a long name (8 characters identifier) and with a sort
name (4 characters identifier) that can be set in the procome configuration file.
The control data that can be configured can be classified in digital signals, measurements and operations. The user can
configure some PROCOME parameter in the f650procome.conf file and then send this file to the relay. The parameters that
are possible to configure are:
Digital signals:
5
Figure 5–63: DIGITAL SIGNALS CONFIGURATION
GEK-106310AB F650 Digital Bay Controller 5-167