Reading Indications From The Pc With Digsi 5 - Siemens SIPROTEC 5 Manual

System Functions
3.1 Indications

Reading Indications from the PC with DIGSI 5

3.1.3
Procedure
Menu Path (Project)
Project → Device → Process data → Logs →
Project → Device → Device information → Logs →
To read the indications with DIGSI 5 your PC must be connected via the USB user interface of the on-site
²
operation panel or via an Ethernet interface of the device. A direct connection to your PC can be estab-
lished via the Ethernet interfaces. It is also possible to access all connected SIPROTEC 5 devices via a data
network from your DIGSI 5 PC.
To reach the desired logs of the SIPROTEC 5 device, use the project-tree window. If you have not set up
²
the device within a project, you can also attain this via Online access.
After selecting the desired log, you are shown the last state of the log loaded from the device. To update,
²
it is necessary to synchronize with the log in the device.
To execute a synchronization with the logs, click the appropriate button in the headline of the log (see
²
the following figure).
[sc7kemel-220213-01.tif, 1, en_US]
Figure 3-2
You will find additional information about the deletion and saving of logs in chapter
Deleting the Log
To determine a relative time for all other indications, you can reference the display of log entries, if
²
needed, to the real time of a certain entry. The real-time stamps of events remain unaffected.
For this purpose, click the appropriate button in the headline of the log (see
²
44
DIGSI 5 Display of an Indication List
.
Log
Operational log
Setting-history log
User log 1
User log 2
Sequence of events
Security log
Device-diagnosis log
3.1.10 Saving and
Figure 3-2).
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017