Function-Group Type Voltage/Current 1-Phase; Overview Of Functions; Structure Of The Function Group - Siemens SIPROTEC 5 Manual

Function-Group Types

6.2 Function-Group Type Voltage/current 1-Phase

6.2 Function-Group Type Voltage/current 1-Phase

Overview of Functions

6.2.1
The Voltage/current 1-phase function group determines the measured values from the connected current
and voltage channels.
The following function blocks work in the Recorder routing VI function:
•
Routing f
•
Routing I
•
Routing power
•
Routing V
NOTE
i
i
The Voltage/current 1-phase function group works with a voltage measuring point, with a current meas-
uring point, or with a voltage and current measuring point. Depending on the connected measuring points,
the voltage, frequency and power functions (measured values, trigger and recorder routing functions) are
not available.
For more information about the embedding of the functions in the device, please refer to chapter
Embedding in the
The entire function scope of the application templates can be found in chapter
Functional Scope for the Fault Recorder

Structure of the Function Group

6.2.2
The function group Voltage/current 1-phase always contains the function block General, which cannot be
deleted.
You can load the trigger functions required for your application in the function group. These trigger functions
are available in the Global DIGSI 5 library. Trigger functions that are not needed can be deleted again from the
function group.
The following figure shows the structure of the function group Voltage/current 1-phase:
140
Device.
.
2.1 Function
4.2 Application Template and
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017