Fault Recorder
7.1 Introduction to DIGSI 5
NOTE
i
i
The Mode of the individual recorder depends on the settings of the parameter Mode in the higher-level
function General.
The status of the function resulting from the parameter Mode and the superordinate state of the recorder is
shown in the following table.
Table 7-1
General Function
(Superordinate State)
Individual recorder
Individual recorder
Individual recorder
NOTE
i
i
Every change of a recorder parameter (with the exception of changing the mode and trigger parameters)
results in a restart of the device.
NOTE
i
i
A currently existing trigger violation does not trigger fault records if
•
the device is restarted
•
the device, the recording, or the mode of the recorder is switched from on to off.
Configuring Trigger Routing
You can route triggers to recorder instances. A trigger can be routed to one or more recorder instances. To
generate a fault record, assign the triggers to the recorders.
Double-click Recorder interaction in the project tree in DIGSI 5.
²
Right-click X (routed).
²
224
Resulting State of the Function (from Connection of Parameter Mode and Superordinate State)
Mode
State of the
Recorder
On
On
On
Off
Off
Test
Test
Mode
State of the
Recorder
Off
On
Off
Off
Off
Test
Off
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
Mode
State of the
Recorder
Test
On
Test
Off
Off
Test
Test