Siemens SIPROTEC 5 Manual page 141

[dw_structure FG VI 1-phase, 1, en_US]
Figure 6-4
The function group has interfaces to the voltage and current measuring points.
The recorder routings allow the routing of the individual measured values to the various recorders. The
following figure shows the structure of the Recorder routing VI function group.
[dw_recorder routing FG VI 1-phase, 1, en_US]
Figure 6-5
You can find more information on the Recorder routing VI function in the chapters
Parameters and Routing in DIGSI 5
Interface with Measuring Points
The function group receives the required measured values via the interfaces to the measuring points. If you
add functions to the function group, they will automatically receive the measured values from the respective
voltage or current measuring points. If you add functions to the function group but the measuring point
necessary for this is not connected, DIGSI 5 reports an inconsistency.
Configure the measuring points in DIGSI 5 via the Function group connections editor. You can find more
detailed information in chapter
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
Structure of the Voltage/Current 1-Phase Function Group
Structure/Embedding of the Recorder Routing VI Function
and 7.6.1.2 Using Measurands
7.1.2 Step 1: Creating a New Project and Adding a New Device
Function-Group Types
6.2 Function-Group Type Voltage/current 1-Phase
7.1.3 Step 2: Setting the
.
.
141