Function-Group Types
6.3 Function-Group Type Voltage/current 3-Phase
For more information about the embedding of the functions in the device, please refer to chapter
Embedding in the
The entire function scope of the application templates can be found in chapter
Functional Scope for the Fault Recorder
6.3.2
Structure of the Function Group
The function group Voltage-current 3-phase always contains the function block General that cannot be
deleted.
You can load the trigger functions required for your application in the function group. These trigger functions
are available from the Global DIGSI 5 library. Trigger functions that are not needed can be deleted again from
the function group.
The following figure shows the structure of the function group Voltage-current 3-phase.
[dwfgspst-240812-01.tif, 4, en_US]
Figure 6-8
The function group has interfaces to the voltage and current measuring points.
The recorder routings enable the routing of the individual measured values to the various recorders. The
following figure shows the structure of the Recorder routing VI function group.
146
Device.
.
Structure of the Voltage-Current 3-Phase Function Group
2.1 Function
4.2 Application Template and
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017