Siemens SIPROTEC 5 Manual page 216

Fault Recorder
7.1 Introduction to DIGSI 5
[scpro7ke-200515, 1, en_US]
Figure 7-3
When you have entered a product code, click Check. If the product code is valid, the Select an applica-
²
tion template list box is activated.
If the product code is invalid, you receive specific error messages. Correct the product code.
When you click Configure, this closes the current dialog and changes to the manual configuration mode.
The Network view is displayed in the operating range.
More details on the product code and on the Configure button is found in the DIGSI Help, Chapter
Adding a new device.
Step 2: Select Device Characteristics
If the device characteristics are completely specified by the product code, the check box Step 2: Select
²
device characteristics is dimmed and can not be edited.
You can find more details on this button in the DIGSI Help, Chapter Adding new device.
Step 3: Select an Application Template
You can carry out this step only if you have selected the device type and the device characteristics, if appli-
cable.
Select the application template you wish to use as a basis for your engineering from the list box.
²
216
Entering Product Code
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017