Function-Group Types
6.2 Function-Group Type Voltage/current 1-Phase
example, as seen by the consumer) as positive. With the P, Q sign parameter, you can invert the sign for
these components. This inversion does not influence any protection function.
6.2.4
Write-Protected Settings
The settings listed here are used primarily for understanding during configuration of the function groups. They
are calculated on the basis of other settings and cannot be directly changed.
Addr.
Rated values
_:9421:103
Power-system data
_:9421:214
_:9421:223
Settings
6.2.5
Addr.
Rated values
_:9421:101
_:9421:102
Measurements
_:9421:150
Information List
6.2.6
No.
General
_:9421:52
_:9421:53
Group indicat.
_:4501:55
_:4501:57
Reset LED Group
_:13381:500
_:13381:320
144
Parameter
C
General:Rated apparent
power
General:M I-1ph uses
MeasP with ID
General:CT mismatch M
I-1ph
Parameter
C
General:Rated current
General:Rated voltage
General:P, Q sign
Information
General:Behavior
General:Health
Group indicat.:Pickup
Group indicat.:Operate
Reset LED Group:>LED reset
Reset LED Group:LED have been reset
Setting Options
-1.00 MVA to -1.00 MVA
0 to 100
0.00 to 100.00
Setting Options
1 A to 100 000 A
0.20 kV to 1200.00 kV
•
not reversed
•
reversed
Data Class
(Type)
ENS
ENS
ACD
ACT
SPS
SPS
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
Default Setting
0.00 MVA
0
0.00
Default Setting
1000 A
400.00 kV
not reversed
Type
O
O
O
O
I
O