[scapp7ke-200515, 1, en_US]
Figure 7-4
Step 4: Select the Communication Versions
The check box Step 4: Select the communication versions is dimmed. This selection is intended for future
activations.
You can find more details on this button in the DIGSI Help, Chapter Adding new device.
To add your new device to the project, finally click OK.
²
Step 2: Setting the Parameters and Routing in DIGSI 5
7.1.3
After you have added the fault recorder in DIGSI 5, you can set parameters and route signals, indications, trig-
gers, etc.
The sequence of the routing in DIGSI 5 corresponds to the signal flow direction.
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
Select the Application Template
Fault Recorder
7.1 Introduction to DIGSI 5
217