Bay Setup - Toptech Systems MultiLoad II User Manual

Chapter 4 – General Configuration
DC Input
DC Output
DC Output
DC Output
B
4.8.1 AY
Use the Bay Setup functions to configure all Bay level configurations.
Navigate to this screen as: Program Mode -> Configuration -> Equipment Setup -> Select Parameter Level -> Bay
Setup
All Weights and Measures controlled values are displayed in red both on the screen and in this manual.
The Bay Setup screen displays:
Parameter
Number Bay Presets
(Excluding SMP & SCS)
Number of FCMs
Number of PCMs
(Excluding SCS)
Temperature UOM
Canada API Limits
Number of Tanks
(SCS Only)
Firmware Version 3/4.31.37
Port 9
Port 10
Port 11
Port 12
S
ETUP
Number Bay Presets:
Number of FCMs:
Number of PCMs:
Temperature UOM:
Canada API Limits:
Number of Tanks:
Start Transaction FCM#:
Stop Transaction FCM#:
Bay Number:
Number External Presets:
Output Pulse FCM#:
Output Pulse Factor:
Deadman Mode:
Input Deadman FCM#:
Next
Description
Enter the number of presets (load arms) that will be controlled by this MultiLoad II.
Enter the number of Flow Control Modules (FCM) including the I/O board that will be
attached to this bay. The maximum number of FCMs that can be attached to a bay is 32 (1
on MultiLoad II SMP).
Enter the number of Printer Control Modules (PCM) that will be attached to this bay.
This selection indicates whether temperatures will be in Fahrenheit or Celsius. Select
"F" to choose Fahrenheit or "C" to choose Celsius.
When enabled, API tables will use extended temperature ranges as required by
Measurement Canada.
Enter the number of Tanks that are connected to the MultiLoad.
Ground input

BAY SETUP

C
DISABLD
DISABLD
DISABLD
10.000
NONE
DISABLD
Prev Exit Enter
1
1
0
0
0
0
0
96