Chapter 4 – General Configuration
In the following topics, only Bay Alarm Setup screen is shown.
To change each alarm you need to push ENTER to go into the ALARM DETAIL SETUP SCREEN
Alarm
Alarm Name
Alarm Level
Promo Count
Promo
Alarm Level
Promo
Reset Mode
Alarm Host
FCM Output#
Batch Alarm Mask
Send eMail
Notification
Require
Authentication
Firmware Version 3/4.31.37
ADDITIVE ALARM DETAIL SETUP
Alarm Name: *ADTV FCM
Alarm Level:
Promo Count:
Promo Alarm Level:
Promo Reset Mode:
Alarm to Host:
FCM Output#:
Batch Alarm Mask:
Send eMail Notification:
Require Authentication:
Next
Meaning
This is the name of the alarm only a few alarms can be renamed.
This is the general level of the alarm, how it can be cleared. If the alarm is by default not in
AUTO level, it can be never put into this level.
The amount of times the alarm needs to happen before it goes into the Promo Alarm Level.
This is actually has the same levels as the Alarm Level, but is only be used when the
promo count is reached.
The parameter indicates how the promo count can be reset back to zero.
The parameter Alarm to Host , can be set to Remote which means that the alarm is send to
the host.
Alarm Local means the alarm will be seen by any host-system.
If this the general happens on the MultiLoad we will send a general output to a PLC
This feature will disable the storage and printing of a certain alarm if it is not wanted.
Has effect on Printing Bol, Printing Alibi Log, and storage of an alarm.
Send an email with the alarm name and bay number to the email address.
If this parameter is enabled, a login screen will be displayed when attempting to clear the
alarm from one of the loading screens. It will also prevent a host system from clearing this
alarm with one of the meter commands. When a user successfully clears the alarm, a
message will be logged capturing a record of who cleared the alarm.
Note: The alarm level must be set to REMOTE or higher.
Prev
Exit
Enter
AUTO
01x
AUTO
CLEAR
REMOTE
DISABLD
DISABLD
DISABLD
DISABLD
135
Need help?
Do you have a question about the MultiLoad II and is the answer not in the manual?
Questions and answers
Greetings, how can multiload ll totalizers be reset?
The resettable totalizers on the Toptech Systems MultiLoad II can be reset using the CLR (Clear) key. Non-resettable totalizers cannot be reset.
This answer is automatically generated