Table of Contents
Advertisement
Chapter 4 – General Configuration
P
4.16.1
RESET
The Preset can be assigned a name. This is will be displayed before the driver makes a product selection.
C
4.16.2
OMPONENT
After defining your base components, this function allows assignment to the physical component.
When selected the Component Selection Screen is displayed:
Configure the assigned Base Component as shown in the example below.
Firmware Version 3/4.31.37
N
AME
A
SSIGNMENT
PRE #1 (Preset 001) COMPONENT SELECTION
Comp #1: BAS001 Base 001
Next
PRE #1 (Preset 001) COMPONENT SELECTION
Comp #1: 000123 BASE87UNL
Next
Prev
Exit
Enter
Prev
Exit
Enter
155
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiLoad II and is the answer not in the manual?
Questions and answers
Greetings, how can multiload ll totalizers be reset?
The resettable totalizers on the Toptech Systems MultiLoad II can be reset using the CLR (Clear) key. Non-resettable totalizers cannot be reset.
This answer is automatically generated