Toptech Systems MultiLoad II User Manual page 400

Chapter 13 – Custom Logic
Gross Creep Delivery
Additive Real Time (RT)
Firmware Version 3/4.31.37
Parameter
Gross Flow Rate
Temperature
Pressure
Density
Relative Density
API Gravity
Volume Preset
Parameter
Clearing Errors
Clear Batch
Test Button
Pump Run
Description
The current gross flow rate, measured from the
specified meter, for the current batch. The value is in
whole units.
The current temperature reading associated with the
specified meter. The value is in hundredths, with an
inferred decimal.
The current pressure reading associated with the
specified meter. The value is in hundredths, with an
inferred decimal.
The current density reading associated with the
specified meter. The value is in tenths, with an inferred
decimal.
The current relative density reading associated with the
specified meter. The value is in ten thousandths, with
an inferred decimal.
The current API gravity reading associated with the
specified meter. The value is in tenths, with an inferred
decimal.
The gross volume that has flowed through the specified
meter when there shouldn't have been. Value is in
whole units.
Indicates the target volume that is intended to flow
through the specified meter based off the value entered
in by the driver. Value is in hundredths with an implied
decimal.
Description
Indicates that an additive-level alarm is clearing for a
particular additive.
Indicates that additive totals of a particular injector are
being archived.
Indicates that the Test Button used in injector
calibration has been pressed for a particular injector.
Indicates that a particular Additive's pump has been
commanded to run.
400