Table of Contents
Advertisement
Chapter 3 – GUI Configuration Tool
6. Uploading...
7. After the upload is completed the following pop up will appear. Update FLASH firmware
Note: If the W&M access switch is not active, the flash operation will fail since the firmware image is W&M
protected.
8. Warning message that the settings could be lost, depending if the firmware step is small or big.
9. After the upgrade the communication parameters should be re-entered to the MultiLoad.
10. Test the communication again via MultiMate and reload the existing configuration.
Note: Legacy MultiLoad II 1-Arm firmware can be updated to the full MultiLoad II firmware version 2.29.02 or
later.
Firmware Version 3/4.31.37
63
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiLoad II and is the answer not in the manual?
Questions and answers
Greetings, how can multiload ll totalizers be reset?
The resettable totalizers on the Toptech Systems MultiLoad II can be reset using the CLR (Clear) key. Non-resettable totalizers cannot be reset.
This answer is automatically generated