Table of Contents
Advertisement
Chapter 9 – Weights & Measures
Turning on both Upstrm Val and Dnstrm Val at the same time will open the digital control valve
!
and may result in flow (if pumps, block valves, and dry breaks are set correctly).
Driving the mA output to any value greater than 4 mA will open the digital control valve and
!
may result in flow (if pumps, block valves, and dry breaks are set correctly).
If the meter is configured as a Krohne mass meter, the following screen will appear:
Mass Flow
Volume Flow
Density
Temperature
Mass Total
Volume Total
If the meter is configured as a Micro Motion mass meter, the following screen will appear:
Firmware Version 3/4.31.37
PRE #1 MTR #1 KROHNE DIAGNOSTICS
Mass Flow:
Volume Flow:
Density:
Temperature:
Mass Total:
Volume Total:
[1]Communications
[2]Sensor Info
[3]General Setup
[4]Zero Calibration
[5]Density Calibration
[6]Service Page
[7]Register Access
[8]Service Register Access
The current flow rate in the configured mass flow units.
The current flow rate in the configured volume flow units.
The current density in the configured density units.
The current temperature in the configure temperature units.
The total mass of product flowed since power on of the mass meter.
The total volume of product flowed since power on of the mass meter.
0.000000kg/Min
0.000000USGal/Min
1.050000kg/m3
22.991680C
-0.002545kg
-0.670395USGal
Exit
263
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiLoad II and is the answer not in the manual?
Questions and answers
Greetings, how can multiload ll totalizers be reset?
The resettable totalizers on the Toptech Systems MultiLoad II can be reset using the CLR (Clear) key. Non-resettable totalizers cannot be reset.
This answer is automatically generated