Toptech Systems MultiLoad II User Manual page 450

Chapter 16 – Firmware Revision History
Updated serial routines to use integer instead of character configuration
parameters.
Added web server functionality.
Added routines to get and set Ethernet MAC address for new and old processor.
Added ML_Mass build for demo of Krohne meter at ILTA.
Density alarm, 4-20mA values outside 4-20 are to be treated as an error and
density set to zero.
Added time delay on density alarms.
Added code to support uploading new firmware on new processor.
Added ability to support 3 host connections at the same time.
Corrected simulation build processor utilization bug by adding nanosleep call.
Changed firmware version to 3.29.20.
Changed all database versions (except NR3-W&M & Totalizers) to 3.29.20.
5/17/10 3.29.20 WJP (release to QA)
Added Factory Test function to verify the installation of OptoFCMs firmware in
FCM I and FCM II.
5/18/10 WJP Rev 9.26.20
Corrected web display of W&M Log and Event Log.
Increased latest known FCM version to 038.
5/21/10 WJP Rev 9.26.20
Corrected bug that prevented multidropped alibi log printing from releasing the
control line.
6/7/10 WJP
No Changes
7/26/10 WJP
Added W&M protected parameter to enable FCM simulation for demo and debug
purposes. "Simulation Mode" is displayed on loading screen
Updated all logo code to use .c const struct inclusion in place of binary files
for bitmaps.
Minor changes to remove Keil compiler warnings messages.
Corrected bug in standalone card processing when searching for 2nd occurrence of
the same card number with a different PIN.
Moved AT91SAM9G45 Modbus code to use PXA255 super-switch.
Corrected Modbus extended services command execution bug where command execution
would occur at the completion of any write to the ESR, not just at the write of the
last register.
ESR changed from unsigned char to char to eliminate compiler warning.
Added start_alt_high_flow_rate and end_alt_high_flow_rate parameters to delay
entry into and exit from alt high flow for use with the LC bubble detector.
Added preset Permissive Alarm Time parameter to delay the occurrence of a
Permissive Alarm for use with the LC bubble detector.
Added additive Upstream Block Valve parameter to allow the automatic opening of
the additive block valve during additive calibration.
Added logic to allow the delivery of a single side stream component for meter
calibration while in proving mode.
Added logic to mark side stream component as complete when main meter is complete
to prevent side stream from running on when main stream stops.
9/10/10 WJP
Continued debugging of Atmel routines for Card Reader, Real Time Clock, Flash
Memory, LCD Driver, Serial Ports, and Network.
Rewrite and simplify ExL Alphanumeric Entry code.
Firmware Version 3/4.31.37
No impact to existing PXA255 code.
450