Table of Contents
Advertisement
Chapter 3 – GUI Configuration Tool
5.
Confirming the IP-address will cause also a first check if the connection is working. The connection gets
anyhow stored and can be reused when MultiMate gets reopened.
D
3.13.3
OWNLOAD
During the first install of the MultiMate Configuration Tool, there is no Parameter Prompt File. This file describes
the all of the parameters that can be configured on the MultiLoad II. The prompt file must be downloaded from
the MultiLoad II before any configuration files can be created, downloaded or edited. The instructions below
describe the proper procedure to downloading the parameter prompt file from the MultiLoad II.
Note: The language of the parameters in the prompt file is determined by the configuration of the language mode
in the MutliLoad II.
1. Connect via the newly configured connection to MultiLoad (each time the MultiLoad connects to
MultiMate, you will be asked to refresh the prompt file).
2. Store the prompt file in a certain location on your PC, or if available on your Tms6 System.
3. When asked to reload the prompt file, respond with Yes. This will apply fresh downloaded prompts.
Firmware Version 3/4.31.37
P
P
F
ARAMETER
ROMPT
ILE
56
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiLoad II and is the answer not in the manual?
Questions and answers
Greetings, how can multiload ll totalizers be reset?
The resettable totalizers on the Toptech Systems MultiLoad II can be reset using the CLR (Clear) key. Non-resettable totalizers cannot be reset.
This answer is automatically generated