D-Link xstack DGS-3620 series Reference Manual page 1368

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Vendor-ID
Vendor-Type
Attribute-Specific Field
If the user has configured the 802.1p priority attribute of the RADIUS server (for example, priority 7)
and the 802.1X, or MAC based authentication is successful, the device will assign the 802.1p
default priority (according to the RADIUS server) to the port. However, if the user does not
configure the priority attribute and authenticates successfully, the device will not assign a priority to
this port. If the priority attribute is configured on the RADIUS server is a value out of range (>7), it
will not be set to the device.
To assign VLAN by RADIUS Server, the proper parameters should be configured on the RADIUS
Server. To use VLAN assignment, RFC3580 defines the following tunnel attributes in RADIUS
packets.
The table below shows the parameters for a VLAN:
RADIUS Tunnel Attribute Description
Tunnel-Type
Tunnel-Medium-Type
Tunnel-Private-Group-ID
A summary of the Tunnel-Private-Group-ID Attribute format is shown below.
0
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
The table below shows the definition of Tag field (different with RFC 2868):
Tag field value
0x01
0x02
Others
(0x00, 0x03 ~
0x1F, >0x1F)
Defines the vendor.
Defines the attribute.
Used to assign the 802.1p
default priority of the port.
This attribute indicates the
tunneling protocol(s) to be
used (in the case of a tunnel
initiator) or the tunneling
protocol in use (in the case of
a tunnel terminatior).
This attribute indicates the
transport medium being
used.
This attribute indicates group
ID for a particular tunneled
session.
1
Length |
String field format
VLAN name (ASCII)
VLAN ID (ASCII)
1. When the switch receives the
VLAN setting string, it will think it is
the VLAN ID first. In other words, the
switch will check all existed VLAN ID
171 (DLINK)
4
0-7
Value
13 (VLAN)
6 (802)
A string (VID)
2
Tag | String...
Note
A tag field of greater than 0x1F is
interpreted as the first octet of the
following field.
1363
Required
Required
Required
Usage
Required
Required
Required
3