D-Link xstack DGS-3620 series Reference Manual page 78

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#
4-20 create authen server_host
Description
This command is used to create an authentication server host. When an authentication server host
is created, the IP address and protocol are the index. That means more than one authentication
protocol service can be run on the same physical host. The maximum supported number of server
hosts is 16.
Format
create authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius] {port <int
1-65535> | [key [<key_string 254> | none] | encryption_key <key_string 344>] | timeout <int
1-255> | retransmit <int 1-20>}
Parameters
<ipaddr> - Enter the server host's IP address.
protocol - Specifies the server host's type of authentication protocol.
tacacs - Specifies the server host's authentication protocol TACACS.
xtacacs - Specifies the server host's authentication protocol XTACACS.
tacacs+ - Specifies the server host's authentication protocol TACACS+.
radius - Specifies the server host's authentication protocol RADIUS.
port - (Optional) Specifies the port number of the authentication protocol for the server host. The
default value for TACACS/XTACACS/TACACS+ is 49. The default value for RADIUS is 1812.
<int 1-65535> - Enter the port number of the authentication protocol for the server host. The
default value for TACACS/XTACACS/TACACS+ is 49. The default value for RADIUS is
1812. The port number must be between 1 and 65535.
key - (Optional) Specifies the key for TACACS+ and RADIUS authentication.
<key_string 254> - Enter the key for TACACS+ and RADIUS authenticaiton. If the value is
null, no encryption will apply. This value is meaningless for TACACS and XTACACS.
none - No encryption for TACACS+ and RADIUS authenticaiton. This value is meaningless
for TACACS and XTACACS.
encryption_key - (Optional) Specifies the encrypted form key string for TACACS+ and RADIUS
authentication. This value is meaningless for TACACS and XTACACS. The encryption
algorithm is based on DES.
<key_string 344> - Enter the encrypted form key string for TACACS+ and RADIUS
authentication.
timeout - (Optional) Specifies the time in seconds for waiting for a server reply. The default value
is 5 seconds.
<int 1-255> - Enter the time in seconds for waiting for a server reply. The default value is 5
seconds. The timeout value must be between 1 and 255 seconds.
retransmit - (Optional) Specifies the count for re-transmit. This value is meaningless for
TACACS+. The default value is 2.
<int 1-20> - Enter the count for re-transmit. This value is meaningless for TACACS+. The
default value is 2. The re-transmit value must be between 1 and 20.
Restrictions
Only Administrator-level users can issue this command.
73